GAF48V10W Input 10-30V Gigabit Output 48Volts PoE Converter for any 802.3af or 48V devices and solar to Conversion | Безопасность и

GAF48V10W Input 10-30V Gigabit Output 48Volts PoE Converter for any 802.3af or 48V devices and solar to Conversion | Безопасность и

Input 10-30V Gigabit Output 48Volts set up injector PoE Converter for any 802.3af or 48V devices and solar to PoE Conversion

PoE 48v-10w Converter

This device provides a low cost solution for delivering power to a 802.3af or 48 volt device over 328ft of network cable.

This scheme allows power to be carried on 10/100 networks over the spare, unused pairs of a CAT5, CAT5E, CAT6 or

CAT7 Ethernet network cable. The source power is any supply from 10v to 30v, and the output voltage is 48 volts.

Product Specification:

Data + Power in RJ 45 male connector

DC input connector 2.1mm x 5.5mm adapter

Data + Power out RJ 45 Female connector

Network Type 10BASE-T, 100BASE-T

Data Pins 1&2 and 3&6

Power Pins 4&5 + and 7 & 8 -

Input Voltage 10v to 30VDC

Output Voltage 48v +- 2% at .2 amps

Operating Temperature 0°C ~ 50°C

Most Powered Devices support Mode A&B

Product description

Power into the device is either from the 2.1mm DC connector – OR – from the RJ45 male pins 45+ and 78- . Both do not have to be used, just one is required. The device does 10/100 ethernet.

Any battery (12v or 24v) or passive PoE injector can now power a 48 volt device directly. Plug it into spare ports on a multi port Passive PoE injector, or connect it to any 12v to 24 volt power source – and power a Phone, WiFi-Access Point, camera or other device. The higher DC voltage of 48 volts compared to 12 volts, means the wire loss is reduced by a factor of 16 , thus carried with less loss over the spare pairs of the 10BASE-T or 100BASE-T network cable. The remote device extracts the DC voltage from the network cable and powers it’s internal electronics.

The input voltage can be applied to the 2.1mm female connector – or from a passive PoE injector using Mode B ( 45+ and 78-). If power is applied to the 2.1mm input – power will be isolated from the male RJ-45 – so it can be plugged into a switch or router. The data pins of 12 and 36 pass directly thru. The output voltage of 48 volts comes on 45+ and 78- of the female RJ-45.